VERTICAL CONTACT TOASTER
13
P/N 1010838 Rev. D 07/06
Burger King
Replacing Belt Wraps and Measuring
the Conveyor Belt Chains and Roller
Tensioners (Every 3 - 6 months)
REPLACING BELT WRAPS
NOTE: Depending on toaster usage and how well
they are cleaned daily, the black cleated Belt Wraps
should last between 3 - 6 months. Additional Belt
Wraps may be purchased from your Authorized
Service Agency.
1. Turn the Rocker Switch (power On/Off) to OFF,
unplug the power cord, and allow the unit to cool
before proceeding.
2. Remove the Bun Feeder and Heat Shield and set
the Compression Control Knobs to 6 and F.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the “zipper” (Figure 11).
4. Remove and discard the old Belt Wrap(s).
5. Clean both Conveyor Belt Chains just as you
would clean the Belt Wraps during daily cleaning
(Figure 11).
6. Install the new Belt Wrap(s) around the Conveyor
Belt Chains inside the yellow rods with the “zip-
per” flap exposed and hanging down (Figures 12
& 13).
CA
UT
ION
INCORRECT
CORRECT
Figure 12. Installing Belt Wrap
Figure 13. Aligning Belt Teeth
Belt Wrap
Pin
Belt Rotation
Upper Support Rod
Lower
Support Rod
CAUTION
Position the Belt Wrap UNDER the upper and
lower yellow support rods or damage to the unit
may occur.
CAUTION
Align the ends of the Belt Wrap properly (Figure
13) or the Belt Wrap may be damaged.
Figure 11. Removing Belt Wrap
Conveyor
Safety
Interlock
Switch
Conveyor
Cover Assy.
Belt Wrap
Pin
Replacing the Black and Silver Release
Sheet (Every 4 - 6 weeks)
NOTE: Depending on toaster usage and on how
well it is cleaned daily, the black and silver Release
Sheet should last between 45 - 60 days.
1. Remove and discard the Release Sheet.
2. Lay a new Release Sheet on a clean, dry surface
and fold it in half lengthwise and gently crease it
at the fold using only your fingers.
3. Install the Release Sheet just as you would after
daily cleaning (see diagram below).
Fold over so
ends meet.
Press Lightly
with finger to
form crease.
7. Close the Conveyor Cover(s), set the
Compression Control Knobs back to their normal
settings and reinstall the Heat Shield and Bun
Feeder.
Conveyor Belt
Chains
MAINTENANCE (continued)
