INSTALLATION
Follow these instructions to install your prime
outdoor antenna:
Stage 1. UNFOLDING ANTENNA
Grasp a folded element at the back of the antenna,
close to the pivot point (within 300mm) and rotate
outwards until it clicks firmly into place.
Repeat this for the elements on the bottom side.
Continue this work towards the front of the
antenna (See Figure.1).
Fig.1
Stage 2. REFLECTOR ASSEMBLY
Follow below steps to assemble and mount the
reflectors to the antenna boom:
1.
Remove the two UHF reflector assemblies, two
reflector screws and the two wing nuts from the
sealed poly bag.
2.
Locate the two mounting brackets pre-mounted
on the antenna boom. (See Figure 2a)
3.
Fix first UHF reflector to the mounting brackets
on top side of the antenna boom. Make sure
antenna elements are facing towards the front of
the antenna as shown on Figure 2b.
Note: At this stage, fix loosely the first UHF
reflector to mounting bracket as this will provide
more flexibility to place the other UHF reflector in
between the mounting bracket in other stages.
4.
Now, mount the other UHF reflector assembly
in between the two mounting brackets; use one
reflector screw and one wing nut to hold the
reflector in between the two mounting brackets.
5.
Tighten both wing nuts attached to the mounting
brackets clockwise until the two mounting brackets
hold the two UHF reflector assemblies tightly.
Top Reflector
Assembly
Fig.2b
Bottom
Reflector
Assembly
Reflector
Mounting
Bracket
Wing Nut
& Bolt
Fig.2a
Reflector Mounting
Bracket
Antenna Front
3