3
REMOVAL OF AC MAINS POWER
Anton/Bauer recommends that batteries remain on the charger and plugged into AC mains for best results. If AC mains power is removed, it is highly
recommended that the batteries be removed from the charger, thus avoiding any additional self-discharge by the battery.
LED INDICATIONS
Each charge position of a TWIN has a pair of LEDs (one red, one green) that indicate the status of the battery attached to that position.
The following table identi
fi
es all of the TWIN
®
indications and their meaning:
LED INDICATION
MEANING
Alternating
Red & Green
Indicates that the TWIN is evaluating the battery and/or communicating with a
DIGITAL battery, loading battery parameters and determining the appropriate
charge routine. A low voltage (<11V) battery will cause this indication to continue
until the battery is “rejuvenated” to a safe charging voltage.
NOTE: This indication will continue if a non-Anton/Bauer Logic Series
®
battery is
mounted on the charger. These batteries cannot identify themselves to the TWIN
and will not be charged.
Steady Red
Indicates that the battery is being held by the TWIN to stabilize an out-of-range
temperature condition.
Flashing Red
Indicates that the battery is currently under Stage One charge.
Flashing Green
Indicates that the battery is currently under Stage Two charge.
Steady Green
Indicates that the battery is READY and in Stage Three Lifesaver
®
mode.
NOTE: In some cases, a battery may be discharged to a very low voltage level at which the battery is unrecognizable to the charger when
fi
rst
attached. In this case, no indications will appear on the LED display. Each TWIN constantly looks for such batteries, applying small,
safe amounts of charge current to each empty charge position. This search mode occurs continuously.
OPERATION CONTINUED
CHARGE TIMES
The following are approximate charge times for Anton/Bauer Logic Series batteries.
ProPac
®
13/14
3 ½ hours
Digital ProPac
®
13/14
3 ½ hours
Trimpac
®
14
2 ¼ hours
Digital Trimpac
®
14
2 ¼ hours
ProFormer
®
1 ½ hours
HyTRON
™
50
2 ½ hours
HyTRON
™
120
6 hours
HyTRON
™
140
7 hours
Dionic
®
90
5 hours
Dionic
®
160
8 hours
Approved Copy
