-‐ 12 -‐
AntMiner
S
9
Installation
Guide
5. Monitoring Your Miner
5. Monitoring Your Miner
To check the operating status of your miner:
1. Click
Miner Status
.
2. Under AntMiner, monitor your miner according to the descriptions in the following table:
Option
Description
ASIC#
Number of chips detected in the chain.
Frequency
ASIC frequency setting.
GH/S(RT)
Hash rate of each hash board ( GH/s)
Temp(PCB)
Temperature of each hash board (°C).(Applied only to miner with fixed frequency)
Temp(Chip)
Temperature of the chips on each hash board (°C).
ASIC status
One of the following statuses will appear:
●
O
-‐ indicates OK
●
X
-‐ indicates error
●
-‐
-‐ indicates dead
Note:The S9 miner with automatic frequency adjustment firmware will stop running when the
Temp(Chips) reach to 125-‐135°C,there will be a error message “Fatal Error: Temperature is too
high!” shown in the bottom of kernel log page.