Document No: XCCT818
CCT818 ANTIhum.com 8 Channel RF Modulator
Email: [email protected]
Last Updated: 14/08/2012
Channel Programming Steps
1. On the front panel you will see
the channel 1 LED illuminated. This
refers to the video and/or audio
connected to channel 1 inputs.
Each channel has a default video
frequency channel starting from 55
and increasing in steps of 2. Using
these avoids programming.
Installation
1. Connect video and audio inputs
via phono connections at back of
unit.
2. Connect RF out using F
connector co-ax lead into the
analogue aerial downlead using an
aerial combiner part number
AER195 prior to any RF distributor.
3. Plug in the power connector into
240vAC mains supply.
2. If you are unable or cannot use the programmed settings you can change them using the
following steps. With a straightened paperclip you can change the channel selection by
pressing the button in the hole above the MENU. By pressing this button the selection will
move through the eight channels.
3. You will notice that each video/audio channel will show in the LCD display window the
frequency channel number prefixed with a 1. For example audio/video channel 1 may have
155 which is frequency channel 55 and audio/video channel 2 may have 157 which is
frequency channel 57. You can select from 121 ~ 169 which is frequency channels 21 ~ 69.
4. Using a paperclip press the button in the hole above UP to select the next ascending
frequency channel number and by pressing the button in the hole above DOWN to select
the next descending frequency channel number.
5. Of course channels must be set so they do not conflict with existing channels but with the
demise of analogue TV channels, separation and selection are now much easier.
