Advanced Options
Troubleshooting
1. If for some reason there is no video output, try adjusting the EDID dip switch to
“[pin1, pin2]=[ ↑-↓]” or “[pin1, pin2]=[↓-↓]”.
Under “[pin1, pin2]=[↑-↓]”, there should be video output. The only requirement in this
setting is that the display must support at least Full HD 1080p. If the default Full-HD
EDID as described still doesn’t work then switch to “[pin1, pin2]=[↓-↓]” to learn the EDID
from output 1 to customize the EDID information.
(Please note that the display with
lowest resolution must be connected to output 1)
Select to [pin1, pin2]=[↑-↓] - Full-HD(1080p@60) – 12bit 3D video & 7.1ch audio
1) Set the dip switch to “[pin1, pin2]=[↑-↓]”
2) Power on the device
Select to [pin1, pin2]=[↓-↓] – Learning EDID from output 1
1) Set the dip switch to “[pin1, pin2]=[↓-↓]”
2) Power on the device
3) It will automatically learn EDID from output 1
EDID Mode Note
a. If the user wants to change EDID mode, please power cycle the device after
setting the dip switches to the required positions.
Firmware Updates
2. Firmware update can be updated through the Micro-USB.
1) Save the firmware file (.bin) & software into the same folder.
2) Connect the Micro-USB cable between PC and device
3) Open the firmware update software and then device will start to update the firm
ware automatically.
4) After the update process is done, the software will show the “Success” message
and then will close automatically.
5) Power cycle the device to complete the process.
