Anthos SMART TOUCH R7, Operating Instruction

Page: 41 / 90

41 41 EN
R7
- OPERATING INSTRUCTION
5.4. Turbine
Connecting the handpiece and changing the chuck.
Refer to the specific instructions furnished with the handpiece.
Use.
WARNING!
Read the instructions for use of the various turbines.
• The cock ( f ) adjusts the water flow to the spray.
• The cock ( e ) adjusts the amount of air spray for all the instruments.
• Place the instrument in its work position.
NOTE:
instrument activation is indicated by the relative manage-
ment page appearing on the TOUCH DISPLAY.
• The icon buttons available on the TOUCH DISPLAY are the following:
Settable value increase
Settable value decrease
Turbine rotation speed selection
Fibre optics on/off
Independent water supply selection/deselection
(only with S.H.S./S system)
Instrument spray type enable and selection
Row of general operating icons
(see paragraph 5.1.)
Quick selection of power at 1% of the maximum turbine
rotation speed
Quick selection of power at 50% of the maximum turbine
rotation speed
Quick selection of power at 100% of the maximum turbine
rotation speed.
• Use the foot control pedal to start the instrument (see paragraph 5.2).
NOTE
: The turbine cord can also be used to connect the air micro-
motors equipped with 4-way connector and conform to ISO 13294 - Dental
Air Motor.
Fibre optic brightness adjustment.
• To adjust the fibre optic brightness, touch and hold (for at least 2 seconds)
the icon button .
• Adjust the brightness by touching the icon or .
NOTE: the settable value ranges from 1 to 16.
• To confirm the brightness selected, exit this submenu by touching the
icon button .
NOTE:
after 30 seconds of not using the instrument (foot control
lever deactivated), the fibre optics turns off.