31
down if the output signal from the Antex card is too loud. One ex-
ception to setting both sliders at maximum is when playing 2 files
simultaneously. In this case, it may be necessary to lower the
sliders slightly to prevent clipping from occurring when peaks of
both files occur at the same time. Note that this is a subjective
concept; how much degradation of the signal to noise ratio is ac-
ceptable depends on the particular situation.
The VOX control is used to start the recording of a file automati-
cally when the audio source level goes above the threshold set by
the slider. If this control is used, when the card is put in record
mode, the time counter will begin counting, but actual recording
will not begin until the threshold level has been reached. If you
want to be sure recording starts immediately, make sure this con-
trol is set to off.
LR, L+R, and RL controls determine if the file recorded will be
normal stereo, left and right channels combined, or stereo with the
left and right channels reversed.
Summary of Contents for SX-34
