Assembly for Outdoor Use
Due to the higher frequencies used by digital broadcasters, mounting an antenna outdoors will offer greater performance
Line up circle and triangle on base to matching
•
symbols on element.
Insert Base C into element assembly B and turn to
•
the left toward the picture as in Figure 7.
Rotate base to tighten onto element. DO NOT
•
OVER TIGHTEN.
Center Groove
Attach the reflector (grid) to the antenna base by threading
•
the 4 1/2” bolt through the center of the column. Tighten.
Attach antenna to mast using u-clamp.
•
Attach coaxial cable to F connector.
•
DO NOT OVER TIGHTEN
•
Aluminum Bar
U-Clamp
Base
Reflector Grid
U-Clamp
F connector
Cable
Align center groove of base (Figure 5) with
•
the aluminum bar on the reflector (Figure 6).
Fig. 6
Fig. 5
877-825-5572
1699 West Fifth Street
Eureka, MO 63025
www.antennasdirect.com
Helpful Tips:
•
If your cable run is greater than 75’, A pre-amplifier may be required.
•
UHF signals are line of sight. Get as much elevation as practical.
•
Attic Installations will cut 40% -50% of your signal strength.
•
KEEP ANTENNA AWAY FROM POWER LINES
