3.
The side that attaches to devices should be the side that has 2
connectors. This will enable you to connect another device if
you wish.
4.
Connect the far end of the cable to your motherboard on the IDE port,
either IDE 1 or IDE 2.
Fan Installation
The KS-188 case has three 80mm optional fans that can be installed – one
in front and two at the rear.
Note: Antec Cooling Fans blow in the direction that the Antec logo is facing.
Front Fan
1.
Squeeze the sides of the fan cage near the speaker to release pres-
sure on the tabs. Once loose, you should then be able to pull the cage
back and out of the case.
2.
Drop the fan into the cage and push it in until it clips in. No screws are
needed.
3.
Reattach the cage/fan assembly to the case paying attention to the
wires of the fan. There are slots near each corner to put the wires
through (any corner will work, find the one that’s best for you).
4
Connect the 4-pin male connector to a 4-pin female connector coming
out from the power supply.
Rear Fan
There are two fan grills right behind the rear 3.5” drive cage.
1.
Line up the screw holes of the fan to the screw holes on the back of
the case that surround the fan grill.
2.
Holding the fan in one hand, insert the screw from the outside into the
case/fan screw holes.
3.
Connect the 4-pin male connector to a 4-pin female connector coming
out from the power supply.
4.
Repeat the same procedure for the other fan.
