Antari HZ-100, User Manual

Page: 3 / 8

3
․ Use only dealer recommended Antari high-quality hazer liquid (HZL). Please do not
use any other liquid which may cause erosion of inner parts.
․
If your Antari Hazer fails to work properly, discontinue use immediately. Drain all
hazer liquid from the tank, pack the unit securely (preferably in the original packing
material), and return it to your ANTARI dealer for service.
․
Please note before sending the machine for transporting purpose, make sure the
liquid inside the tank is fully emptied.
․
Never drink hazer liquid. If it is ingested, call a doctor immediately. If hazer liquid
comes in contact with skin or eyes, rinse thoroughly with water.
Pay attention to all warning labels and instructions printed on the exterior of your Antari
Hazer
• Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system
has arrived intact. Before beginning initial setup of your ANTARI Hazer, make sure that
there is no evident damage caused by transportation. In the event that the unit’s housing
or cable is damaged, do not plug it in and do not attempt to use it until after contacting
your Antari dealer for assistance.
• Setup
1. Remove all packing materials from the shipping box. Check that all foam and plastic
padding is removed.
2. Place hazer on a flat surface and remove hazer liquid tank cap.
3. Your hazer may come with standard Timer remote HC-1 or Wireless HCR-1 remote
(except HZ-100, which will come separately). If you will be controlling your unit
remotely, firmly attach the remote control cable to the proper position.
• Operation
1. Place the unit on a flat surface. Plug power cord into a grounded electrical outlet.
2. Set the power switch to “ ON ” on the back of the machine. Make sure that the red
indicator light is on.
3. Remove the black liquid tank cap, pour hazer liquid into the liquid tank about 1/2 full,
be careful not to exceed the maximum fluid level. DO NOT OVERFILL. Use only
dealer-recommended high-quality hazer liquid . Any other types of fluid may cause
health hazard and damage the unit. Use of any other liquid may void warranty.
4. Connect the remote controller to the unit, press the red button ON/OFF to start up the
unit. (For further information on operating (including DMX) your Antari HZ-100, 300,
and 400 Hazer, see the section titled, ”Remote Control Operation”).
5. There’s an adjustable nozzle blade where you can adjust the angle of the haze output
by adjusting the thumb screws indicated below: