5
Product Overview
Setting Up
Step 1:
Place the machine on a flat surface and in a suitably large area with at least 50 cm
of open space around the machine.
Step 2:
Fill the fluid tank with Antari approved fluid.
Step 3:
Connect the machine to a suitably rated power supply. To determine the power
requirement for the machine refer to the label on the back of the machine.
Always connect the machine to a protected circuit and ensure it is properly
grounded to avoid risk of electrocution.
Step 4:
Turn on the machine and allow it to heat up. Heat up takes approximately 10
mintues. Once the machine has reached operating temperature, the LCD display will show
“Ready To Fog”. Now the machine is ready for operation.
Step 5:
To start making fog, locate the rotary knob on the right side of control panel, and
press the
rotary knob to start making fog.
Step 6:
To turn off the machine, press rotary knob again button and turn Powercon to the
OFF
position.
XLR 5-Pin DMX Connector
XLR 5-Pin DMX Connector
Remote Control (Z-3 Remote)
Wireless Receiver
(W-2 Wireless Remote)
Two rotary knobs
Timer / Volume
