Antari 80374, Manual, Page: 9 / 20

8
Product code: 80374
Antari AF-5E DMX Fan
Installation
Remove all packing materials from the AF-5E. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the device in, always make sure that the power supply matches the product
specification voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice
versa.
Connect the device to the main power supply.
Control Modes
There are 2 modes:
● Manual
● DMX-512
One AF-5E (Manual)
01)
Place the AF-5E on a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the AF-5E is not connected with a DMX cable, it functions as a stand-alone device.
04) Please see 1. Manual Mode on page 10 for more information.
Multiple AF-5Es (DMX Control)
01)
Place the AF-5E on a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Use a 5-pin XLR cable to connect the AF-5E and other devices.
04) Link the devices as shown in Fig. 02 on page 9. Connect a DMX signal cable from the first device's
DMX "out" socket to the second device's "in" socket. Repeat this process to link the second, third, and
fourth devices.
05) Supply electric power: Plug electric mains power cords into proper electric power supply sockets,
starting with the first device. Do not supply power before the whole system is set up and connected
properly.