Antaira Technologies - Industrial Ethernet Switches
LMX-2828G-10G-SFP Hardware Manual V1.0
9
3. Mounting Installation
3.1 Rack Mounting
The switch comes with a rack-mounted kit which can be mounted in an EIA standard size, 19-inch
rack. It can be placed in a wiring closet with other equipment.
Perform the following steps to rack-mount the switch:
1. Position one plate to align with the holes on one side of the hub and secure it with the
smaller plate screws. Then, attach the remaining plate to the other side of the switch.
2. After attaching both mounting plates, position the switch in the rack by lining up the holes in
the plates with the appropriate holes on the rack. Secure the switch to the rack with a
screwdriver and the rack-mounting screws.
*Note:
For proper ventilation, allow at least 4 inches (10 cm) of clearance on the front and 3.4
inches (8 cm) on the back of the switch. This is especially important for enclosed rack
installation.
Figure 3.2
– Mount the Switch in an EIA Standard 19-inch Rack
Figure 3.1
– Attach Mounting Plates with Screws