Antaira Technologies - Industrial Ethernet Switches
LMP-1802G-M12-10G-SFP-67-110 Series - Hardware Manual - v1.0
PoE
Amber
On
Supplying power to the powered-device
Off
Not connected to a powered device
SFP Port
17~18
Green
On
Connected to network, 10Gbps
Flashing
Networking is active
Off
Not connected to network
Amber
On
Connected to network, 1Gbps
Flashing
Networking is active
Off
Not connected to network
Table 2.1 - LED Indicators
Note:
“P1” is the abbreviation for “Power 1”, “P2” is for “Power 2”, “LNK” is for “Link”, and “ACT” is for “Activity”.
2.5 Reset to Default
Please perform the steps below to reset the switch to factory default setting.
Step 1: Reverse the Tx & Rx of the console cable and plug it into the console port.
Step 2: Restart the power.
Step 3: The switch will start rebooting with the port LEDs flashing.
Step 4: When the status LED turns into Green, the process is completed.
Step 5: Remove the reversed console cable.
2.6 Ethernet Ports
●
M12 Interface (Auto MDI/MDI-X)
○
Connection Format: M12 8-Pin X-Coded Female Connector
○
Transmission rate: 10/100/1000Mbps
Prepare the M12 8-Pin X-Coded Ethernet Port mating cable for Ethernet connection. The M12 X-Coded Ethernet ports are
auto-sensing for 10Base-T, 100Base-TX, or 1000Base-T devices connections. Auto MDI/MDI-X means that you can
connect to another switch or workstation without changing straight through or crossover cabling. See pin assignment
shown in Table 2.2.
