Antaira Technologies - Industrial Wireless Access Points
ARS-7235-AC Series - Hardware Manual - v1.0
4 Hardware Installation
4.1 Installation Steps
This section will explain how to install the industrial wireless access point:
Caution: This device is intended for indoor use.
Attention: Cet appareil est destiné à une utilisation en intérieur.
Caution: The device is intended to be installed in an industrial control enclosure and panel.
Attention: L'appareil est destiné à être installé dans une armoire de commande et un panneau
industriels.
Installation Steps
1. Unpack the industrial wireless access point from the original packing box.
2. Check if the DIN-Rail bracket is screwed on the industrial wireless access point.
●
If the DIN-Rail is not screwed on the industrial wireless access point, please refer to the
DIN-Rail Mounting section for DIN-Rail installation.
●
If it is required to wall mount the industrial wireless access point, please refer to the Wall
Mounting section for wall mounting installation.
3. To hang the industrial wireless access point on a DIN-Rail or wall, please refer to the Mounting
Installation section.
4. Power on the industrial wireless access point and then the power LED light will turn on.
●
For the help on how to wire power, please refer to the Wiring the Power Inputs section.
●
Please refer to the LED Indicators section for LED light indication.
5. Prepare the twisted-pair, straight-through category 5 cable for Ethernet connection.
6. Insert one side of the RJ45 cable into the wireless access point’s Ethernet port and on the other
side into the networking device’s Ethernet port, e.g. switch PC or server.
14
