Connecting Serial Cable and Setting Serial Parameters,
Continued
3-3
Step 2. Set PC
Programmer
Communication
Parameters,
Click the Start button. Point to Programs and select Panel Programmer. When the choices
appear, select Programmer.
1.
Click on the Programmer application’s Transfer menu and select Settings. A dialog similar
to the one shown in Figure 3-2 appears.
2.
Set the parameters to the settings listed earlier in this section.
Figure 3-2. Serial Port Settings
Step 3. Set
AUTOPULSE Z-28
FACP Baud Rate
Switches 2-1 and 2-2 on the AUTOPULSE Z-28 FACP set the panel’s baud rate. Table 3-1
summarizes the possible settings for these switches, and Figure 3-3 shows their location.
Make sure the baud rate you set on the AUTOPULSE Z-28 FACP matches the baud rate set for
the PC Programmer software.
Figure 3-3. Using Switches SW2-1 and SW2-2 to Set Panel Baud Rate
Table 3-1. AUTOPULSE Z-28 Baud Rate Switch Settings
Baud Rate
SW2-1
SW2-2
OFF LINE
ON
ON
9600
OFF
ON
19,200
ON
OFF
OFF LINE
Black indicates switch positio
9600
19,200
Black indicates switch position.
