EN
11
head (K) on the post using the screws
(M8).
4. Fit the lower part (E) of the lamp post on
the base (D) using the screws (M3).
5. Fit the base (D) on the anchor rods (B)
using a nut and washer (M1).
6. Adjust the lamp post to the height
required and secure the upper part of the
lamp post using the screw (M3).
M1. M10 nut and washer
M3. Screw M6 x 16
M4. Screw M5 x 10
M5. Screw M5 x 5
M7. Nut
M8. Screw
FIG. 1
ASSEMBLY
BASE
1. Dig a hole with an even bottom, size 25 x
25 x 14 cm (l x w x h).
2. Pull the power cords through the bottom
of the hole and 25 cm above ground level.
3. Fit the three anchor rods (B) on the
triangular support (A).
4. Pour ready-mixed cement into the hole.
Place the anchor rods and support
vertically in the cement. Fill with cement
to ground level.
5. Make sure the anchor rods fit the lamp
post base (D). If not, rotate the rods to the
correct position.
6. Install the lamp post when the cement
has set.
INSTALLATION
1. Fit the adapter (I) to the upper lamp post
(H) using the screws (M5).
2. Insert the wires for the lamp housing (J)
in the adapter (I) and fit the lamp on the
adapter using the nut (M7) and threaded
pin (M6).
3. Undo the post head (K) and connect the
lamp housing wires and the prepared
wire (not supplied). Connect a brown wire
to brown, yellow/green to yellow/green,
and a blue wire (neutral) to blue. Pass the
wires through the upper and lower lamp
post respectively (G) and (D). Fit the post
Summary of Contents for 422-075
Page 3: ...1...
