Size (WxH): 126x180 mm
USERS MANUAL • DIGITAL REMOTE CONTROL
408056
DISPLAY DESCRIPTION (pic 1)
1. Memory sets, Max: 12 sets
2. Time: 24 hour display
3. The setting time of indicated receiver for "OFF"
4. The setting time of indicated receiver for "ON"
5. Unit code display;16 units of indicated rec all
6. Battery low display
7. Timer setting "ON" and "OFF" for daily cycle mode
8. Timer setting "ON" and "OFF" at one time mode
9. Random setting time
10. ON/OFF transmission signal indicator
BUTTON DESCRIPTION (pic 2)
UNIT:
The select button of unit code on receiver
ON:
To turn the receiver "ON"
OFF:
To turn the receiver "OFF"
TIMER:
Timer setting
▲:
To select up
▼:
To select down
CLOCK:
For setting time
ENTER:
Enter and confirm
ll/DEL.:
Pause and delete function
FUNCTION
• Wireless remote timer
• 12 memory sets for timer each 24-hour
• Easy and convenient to use
• 3 different setting modes are selectable:
1.
Daily, the timer runs every day with the same
time setting until the timer is turned off.
2.
One time setting, the timer executes the
programmed time settings one time only.
3.
Random function, if there are several ON/OFF
time settings programmed then the remote control
chose wich time to use to turn i.e. a lamp on or off.
This is a very good function as it prevents the lamps to
turn on and off at exactly the same time every day.
• Range approximately 30 m
REPLACING THE BATTERY (pic 3)
The remote control has 2 batteries; 1xCR2032 3V Lithium
for the display and 1xCN23A 12V for transmitting the
signal.
• Remove the lid on the back side of the remote control.
• Remove the CN23A battery. You may have to use a
pen or something similar to then push the CR2032
battery out of its socket.
Note: When replacing the lithium CR2032 battery
then the memory will be reseted. Press the RESET
button to reset the display to normal mode. Use a
paper clip or similar tool to press the RESET button.
USAGE AND PROGRAMMING
Before proceeding the programming of the timer, you will
need to set the correct time.
SETTING THE CLOCK (pic 4)
The timer display the time in 24 hours mode.
• Press "CLOCK" button for 3 seconds, the digits on
LCD display will start to blink.
• Use "▲▼"-buttons to set the hour. Press "ENTER"
button to confirm the correct hour.
• Once again repeat the above action to set the minute
and press "ENTER" to confirm the correct minute. The
clock is now set.
CONTROL RECEIVERS ON/OFF
You can control 16 individual rec all.
Press "UNIT" button or "▲▼"-buttons to select the recei
-
ver that you want to control and press "ENTER" button.
Pressing ”ON” button will turn receiver on and pressing
”OFF” button will turn receiver off.
1
2
Tryck på
RESET efter
batteribyte
3
Summary of Contents for 408-056
Page 12: ......
