Anslut 016233, Operating Instructions Manual

Page: 10 / 20

EN
10
WARNING!
New installations and extensions to existing
installations should always be carried out
by an authorised electrician. If you have
the necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
Symbols
Approved as per
applicable directives.
Warning: Risk of electric shock.
Class II.
The condition to use the
luminaires with limited outer
surface temperature has been
specified in EN 60598-2-24.
The luminaire cannot be used
with the light source of the
voltage more than 1000V,
due to the risk of combustible
dust, which will not explode
in the atmosphere but will
accumulate on the luminaires,
exists.
Recycle discarded product
as electrical waste.
SAFETY INSTRUCTIONS
• Disconnect the power supply before
installation.
• Check that the rated voltage corresponds
to the mains supply voltage.
• Do not connect the product to the mains
while it is still in the pack.
• Check that all electrical cables comply
with the applicable regulations and that
they are connected in accordance with the
instructions.
• Never overload the mains. This can result
in fire or a risk of electric shock.
• Keep out of the reach of children.
• Do not store the product in a very cold/
hot place to avoid damaging the
electronics.
• The electronics in the product are sensitive
to knocks and blows. Avoid dropping it.
• Never attempt to replace damaged
electrical cables yourself.
• The light source of this luminaire is not
replaceable; when the light source
reaches its end of life the whole luminaire
shall be replaced.
• The product is not dimmable.
• Pay attention so that no concealed wires
are damaged in connection with
installation.
• Be careful not to damage the insulation
on the wires during installation. Make sure
that the wires do not come into contact
with sharp edges. Damaged insulation can
result in a risk of electric shock.
• Do not look directly into the light source.
• The minimum safe distance to an
illuminated object is 10 centimetres.
• Products shall be installed in
environments where an accumulation of
conductive dust on the luminaire may be
expected. For locations wiring system
should be complied with EN 60364-4-42.