EN
19
4. Tighten the plastic nut clockwise. Do not
overtighten.
5. Fit the fan rotor on the motor shaft with
the slot on the back of the fan rotor over
the pin in the motor shaft. Turn the fan
rotor by hand after fitting to check that it
rotates smoothly and easily.
6. Remove the screw and nut from the back
edge of the grille.
7. Place the front grille against the back
grille, so that the holes in the edges are
in line.
FIG. 2
8. Put the screw through the hole and screw
on the nut. Do not tighten fully.
9. Press the grille clips in place over the edge
of the grille. Tighten the nut on the screw
that goes through the edge of the grille.
FIG. 3
HOW TO USE
1. Set the required speed with the power
switch:
– 0: Off
– 1: Low speed
– 2: High speed
FIG. 4
2. To activate/deactivate oscillation, pull up/
press down the oscillation button.
FIG. 5
3. Carefully press on the motor part to adjust
the air flow in the vertical plane.
FIG. 6
MAINTENANCE
NOTE:
Pull out the plug from the power point before
installation and/or cleaning.
The fan should be cleaned once a month.
Clean the fan with a soft cloth moistened with
a mild detergent. Make sure that no water or
other liquid gets into the fan.
NOTE:
Do not use petrol, solvents or detergents that
can damage the plastic parts.
Summary of Contents for 014491
Page 3: ...2 1 1 2 3 4 5 6 7 8...
Page 4: ...3 4 5 6...
