Anslut 005730, Operating Instructions Manual

Page: 22 / 24

EN
22
COLD TEMPERATURE WARM UP TIME
Note! Your laser has a warm-up delay in cold
conditions. Please be patient as the laser
warms up between 1 and 10 minutes.
TECHNICAL DATA
Input voltage, transformer 230 V ~ 50 Hz
Output voltage, transformer 12 V DC
Output 6 W
Safety class, transformer
II
Protection rating IP44
Laser wavelength 532/650 nm
Pulse length 100/180 ms
Output <1 mW
Twilight sensor
Yes
Ambient temperature -20 – +35°C
DESCRIPTION
1. Power switch
2. Adjust knob
3. Ground spike
4. Twilight sensor
5. Projector lens
FIG. 1
INSTALLATION
1. Remove all parts from the packaging.
2. Fit the laser light on the ground spike.
3. Press the ground spike firmly in the
ground so that the laser light is stable.
4. Undo the adjust knob, set the required
angle and tighten.
5. Connect the transformer to the mains.
USE
WARNING!
• Do not look directly into the laser beam.
• Laser radiation can cause burn injuries
or permanent damage to the cornea.
1. Adjust the laser light to shine on the
required surface. There is a better effect if
the light is projected onto a dark surface.
2. Plug in the plug and press the power
switch.
3. By pressing the switch as follows nine
different light options are activated:
Number
of times Options
1 Red and green rotating
light.
2 Green rotating light.
3 Red rotating light.
4 Red and green flashing
rotating light.
5 Red and green rapidly
flashing rotating light.
6 Red and green even faster
flashing rotating light.
7 Red and green fixed light.
8 Green fixed light.
9 Red fixed light.
10 OFF.
4. The laser light remains on until switched
off manually, or until the twilight sensor
switches it off when it gets lighter. If
switched off by the twilight sensor it will
also switch on when it gets darker.