11
Rev.C1 of 210602
7. Training
Employers are responsible for providing training to any employee who may be exposed to fall hazards. Training will enable
an employee to recognize and reduce fall hazards. Training must be conducted by a Competent or Qualified Person. Trainer
and trainees must not be exposed to fall hazards during the training course.
8. Inspection
Frequency
Full Body Harnesses must be inspected prior to each use and annually by a “Competent Person” other than the user.
To Inspect Webbing
Bend a portion of the webbing 15-20 cm into an upside-down ‘U’ shape. Continue along all webbing inspecting for tears, cuts, fraying,
abrasion, discoloration, burns, holes, mold, pulled or broken stitches, or other signs of wear and damage.
Adjust all keepers, buckles, padding, and D-ring to inspect webbing hidden by these components.
Sewn terminations must be secure, complete, and not visibly damaged.
Check all buckles for damage, distortion, cracks, breaks, and rough or sharp edges. Inspect for any unusual wear, frayed or cut fibers, or
broken stitching of the buckle attachments. Make sure buckles properly engage.
Ensure that the Quick-Connect buckle’s dual-tab release mechanism is free of debris and engages properly. Double-check the buckle
locking mechanism by tugging on both halves of the buckle to make sure it is firmly connected and will not disengage.
All markings must be legible and attached to the product.
All hardware must be free of cracks, sharp edges, deformation, corrosion, or any evidence of defect.
9. Cleaning, Maintenance and Storage
Cleaning
Full Body Harnesses can be wiped down with a mild detergent and missed with a clean cloth to remove detergent. The hardware can
also be wiped down with a clean, dry cloth to remove grease or dirt.
Maintenance
Any Full Body Harness requiring maintenance must be tagged “unusable” and removed from service.
Storage
n
When not in use, Full Body Harnesses should be stored in a cool, dry place out of direct sunlight.
n
Do not store in areas where damage from environmental factors such as heat, light, excessive moisture, oil, chemicals and their
vapors, or other degrading elements may be present.
n
Do not store damaged equipment or equipment in need of maintenance in the same area as product approved for use.
Equipment must be cleaned and dried prior to storage.
n
Equipment that has been stored for an extended period must be inspected as described in this
User Instructions
prior to use.
10. Material
Webbing:
High tenacity polyester, Minimum breaking strength >5000 lbs.
Pad and Label Cover:
Nylon and polyester blend
Connector:
Alloy Steel