Anritsu Spectrum Master MS2720T, User Manual

Page: 818 / 1035

CDMA Signal Analyzer 2-4 CDMA RF Measurement Setup
3GPP2 MG PN: 10580-00235 Rev. D 2-5
Spurious Emission Setup
This measurement displays the spectrum of the input signal at specific offsets (based upon
the Signal Standard, which is selected from the frequency (
Freq
) menu). Markers are
automatically tuned to measure the input power at these offsets and to determine a PASS or
FAIL according to limits that are set by the signal standard. A blue mask is also calculated
and shown on the spectrum to visually check for pass fail conditions.
From the
Measurement
menu, use the following procedure for Spurious Emission:
1. Press the
RF Measurement
submenu key.
2. Press the
Spurious Emission
submenu key to activate the measurement ( Figure 2-4 ).
The red dot on the submenu key indicates that it is selected.
Figure 2-4. RF Measurement, Spurious Emission
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com