Anritsu Spectrum Master MS2720T, User Manual

Page: 615 / 1035

3-6 Over-the-Air Measurements W-CDMA/HSPA+ Signal Analyzer
3-22 PN: 10580-00234 Rev. T 3GPP MG
W-CDMA Summary Setup
W-CDMA summary ( Figure 3-12 ) displays the critical W-CDMA measurements from RF and
demodulation measurements.
W-CDMA Summary Procedure
1. Set the measurement frequency using one of the methods listed in the User Guide.
2. Press the
Setup
main menu key.
3. Press the
Scrambling Code
submenu key to select
Auto
so that the scrambling code is
automatically detected.
4. The instrument has automatic external reference frequency detection or, if equipped,
activate GPS and synchronize the instrument to High Internal accuracy.
5. Connect the external reference to the
RF In
BNC connector and wait for the unit to
recognize the external reference and lock to it.
6. Press the
S-CCPCH Spread
submenu key to manually set the S-CCPCH spreading.
The default S-CCPCH spreading factor of 256 will be displayed in all the views. Set the
S-CCPCH spreading factor to show accurate results.
7. Press the
S-CCPCH Code
submenu key to enter the correct S-CCPCH code. The default
S-CCPCH code of 3 will be displayed in all the views. Set the S-CCPCH code to show
accurate results.
8. Press the
PICH Code
submenu key to enter the correct PICH code. The default PICH
code of 16 will be displayed in all the views. Set the PICH code to show accurate results.
9. Press the
Threshold
submenu key to manually set the Threshold level to determine
which codes are active. The default value is –30dB.
Figure 3-12. W-CDMA Measurement Summary
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com