Site Master User Guide
PN: 10580-00252 Rev. J
6-1
Chapter 6 — GPS (Option 31)
6-1
Introduction
The Site Master is available with a built-in GPS receiver feature (Option 31) that can provide
latitude, longitude, altitude, and UTC timing information. This option also enhances the
frequency reference oscillator accuracy in the spectrum analyzer mode (S332E/S362E). The
accuracy of the CW generator (Option 28) is also improved with the GPS option. Within three
minutes of satellite acquisition, the reference oscillator will have an accuracy of better than
50 ppb (parts per billion).
In order to acquire data from the GPS satellites, the user must have line-of-sight to the
satellites or the antenna must be placed outside without any obstructions. An Anritsu GPS
antenna is required.
6-2
Chapter Overview
•
Section 6-3 “Activating the GPS Feature” on page 6-1
•
Section 6-4 “Saving and Recalling Traces with GPS Information” on page 6-3
•
Section 6-5 “GPS Menu” on page 6-4
6-3
Activating the GPS Feature
Install the Anritsu GPS antenna onto the
GPS Antenna
connector on the Site Master.
1.
Press the
Shift
key, then the
System
(8) key.
2.
Press the
GPS
submenu key.
3.
Press the
GPS On/Off
submenu key to toggle the GPS feature on or off. When GPS is
first turned on, a RED GPS icon will be appear at the top of the display.
Note
The Site Master Technical Data Sheet provides a list of options and the
measurements that require GPS (Option 31).
Figure 6-1.
GPS Icon, Red
GPS
Summary of Contents for s332e
