Anritsu S331E, User Manual, Page: 58 / 126

4-4 File Menu File Management
4-10 PN: 10580-00252 Rev. K Site Master User Guide
4-4 File Menu
Key Sequence:
Shift
>
File ( 7 )
Save Measurement As: Pressing this key will save instrument setup
parameters, trace data, and any measurement results to the file that is named
on the submenu key. Upon Save completion, the file name numerical suffix
increments by 1 and will be applied to the next Save. The file extension is
determined by the current measurement mode, such as .spa for Spectrum
Analyzer mode, or .dat for Cable and Antenna Analyzer mode.
To save to a different file name than the default shown, or to change the save
location, use the Save Measurement or the Save submenu key.
Save Measurement: Press this submenu key to display the “Save Menu”
and Save dialog box. You can optionally enter a different file name using the
keyboard in the Save dialog. You may also select the file type from the drop
down list, as illustrated in
Figure 4-13 on page 4-11 . The list of available file
types varies with the measurement mode.
Press Enter to save to the named file and return to the File menu. Pressing
Esc exits the Save menu and dialog without saving.
The destination file for the saved data may be in the instrument’s internal
memory or an external drive, typically a USB drive. To change the save
location, refer to the
“Save Location Menu” on page 4-12 .
Save: Press this submenu key to display the “Save Menu” and Save dialog
box. The available settings are the same as those of the Save Measurement
key.
Save on Event (Not available in all measurement modes) : Press this
submenu key to display the “Save On... Menu” on page 4-13 .
Recall Measurement: Press this submenu key to display the “Recall Menu”
on page 4-14 . Use this menu to recall measurement files from internal
memory or an external drive, such as a USB memory stick.
Recall: Press this submenu key to display the “Recall Menu” on page 4-14 .
The available settings are the same as those of the Recall Measurement key.
Use this menu to recall files (such as measurements, setups, limit lines,
maps) from internal memory or an external drive.
Copy: Press this submenu key to display the “Copy Menu” on page 4-15 .
Use this menu to copy files and folders. The source and destination locations
may be the instrument’s internal memory or an external USB drive.
Delete: Press this submenu key to display the “Delete Menu” on page 4-16
and a selection box that lists the contents of internal memory and an external
drive if connected. Use the rotary knob or the
Up/Down arrow keys to scroll to
the file that is to be deleted and press the Select or De-Select submenu key,
then Delete. Press the
Esc key to cancel the operation. Note that deleted files
cannot be recovered.
Figure 4-11. File Menu
File
Copy
Recall
Recall
Measurement
Recall
Save
On
Event
Save
Save Measurement As
FileName_1.spa
Save
Measurement
Delete