Anritsu Network Master MT9090A Series, Operation Manual, Page: 146 / 200

5-4 MT9090A/MU909011A Network Master User’s Guide
Attaching a Probe Tip
Use the following procedure to attach a probe tip to the VIP.
To attach a Probe tip:
1. Remove the dust cap (see item 1 in Figure 5-2 on
page 5-2).
Or –
If a probe tip is already attached, loosen the front
retaining nut (see item 2 in Figure 5-3) until it slides
freely on the Barrel assembly (see item 3 in
Figure 5-3).
Figure 5-3: VIP with Universal 1.25 mm Tip
Note
Do not touch the lens surface (see item 4 in
Figure 5-3).
2. Select the desired probe tip. Make sure that the key
(small set screw on the inside of the threaded end of
the probe tip) aligns with the key channel on the
barrel assembly (see items 3 and 4 in Figure 5-4 on
page 5-5) and slide the probe tip into place.
1.

2.
3.
4.
Probe tip

(1.25 mm Universal)
Front retaining nut
Barrel assembly
Lens