Anritsu MX183000A, Operation Manual, Page: 63 / 226

4.3 Measurement System Configuration
4-9
4
O
per
ation
4.3.3 Entering Compliance Test Mode
When MX183000A is connected to the MX180000A, the 28G/32G PPG
enters Compliance Test Mode and the screen is displayed as Figure
4.3.3-1.
The 28G/32G PPG is operating in Compliance Test Mode, so the normal
test pattern cannot be sent.
Notes:
● Return to normal BERT mode appears as below while adjusting
(Refer to Section 4.3.4 “RF Setting of MX180000A”), but do not
click this button. If clicked, disconnect this software from the
MX183000A and re-connect. (Refer to Section 4.3.2 “Connecting
Measurement Equipment”.)
● If Return to normal BERT mode is displayed even after
disconnecting this software from the MX180000A, click Return
to normal BERT mode to return the 28G 32G PPG to normal
mode.
Figure 4.3.3-1 28G/32G PPG Window (after connecting from MX183000A)
Return to normal BERT mode