Anritsu MG369 Series, Operation Manual

Page: 93 / 268

Selecting a
Power Level
Sweep Range Selecting a power level sweep range consists of
choosing a start and stop level for the power level
sweep. The power level sweep range selection pro-
cess is identical for all power level sweep
modes—CW power sweep and sweep frequency/step
power. You can select a power level sweep range as
follows:
q Edit the current start and stop power level pa-
rameter values
q Enter new start and stop power level parame-
ter values
q Select one of the preset power level sweep
range parameters (
L1-L2
,
L3-L4
,
L5-L6
,
L7-L8
,
or
L9-L0
)
Editing the Current Start / Stop Power Levels
To edit the current power level sweep range, open ei-
ther the start or stop power level parameter. In the
display above,
Edit L1 [XL1]
opens the start power
level parameter and
Edit L2 [XL2]
opens the stop
power level parameter.
Edit the open power level parameter using the cur-
sor control keys or the rotary data knob. When you
are finished, close the open parameter by pressing
its menu edit soft-key or by making another menu
selection.
Entering New Start / Stop Power Levels
To enter a new power level sweep range start by
opening either the start or stop power level parame-
ters (press
Edit L1 [XL1]
or
Edit L2 [XL2]
).
Enter a new power level using the keypad and ap-
propriate terminator soft-key. When you are fin-
ished, close the open parameter by pressing its
menu edit soft-key or by making another menu se-
lection.
MG369XB OM 3-59
Local (Front Panel) Operation Power Level Sweep Operation