Anritsu Company Site Master S312D, Maintenance Manual, Page: 41 / 62

S312D MM PN: 10580-00195 Revision B 3-1
Chapter 3 — Removal and Replacement
3-1 Battery Pack Removal and Replacement
This procedure provides instructions for removing and replacing the Site Master battery pack. Table 2-1 in
Chapter 1, “General Information” provides a list of replaceable assemblies.
1. With the Site Master standing upright on a stable surface, locate the battery access door ( Figure 3-1 ).
2. Lift up the access door handle and rotate it 90 ° counterclockwise, as illustrated in Figure 3-1 .
3. Lift the door and remove, as illustrated in Figure 3-1 .
4. Grasp the battery lanyard and pull the battery straight up and out of the instrument, as illustrated in
Figure 3-1 .
Note
Many of the procedures in this section are generic, and apply to many similar instruments. Photos
and illustrations that are used in this document are representative and may show instruments other
than the Site Master.
Figure 3-1. Battery Pack Removal