Do not drag the assembled unit across any surface.
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
•
Repairs must be made using only factory authorized parts and methods.
•
wArnInG
cAre And
mAIntenAnce
211 No
rth Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web:
anovafurnishings.com
10/2012
5. Locate one of the Cross Braces and position it so that the
mounting hole in one end aligns with the mounting hole in the
bracket in the center of the Seat Support. Place it on the back
side of the bracket. Put a Washer on one of the Bolts and insert
the Bolt through the Cross Brace and Seat Support bracket and
put a Washer and Flanged Nut on the end of the Bolt.
Leave the hardware finger tight so that adjustments can be
made while assembling and leveling.
Install a Bolt and Washer through the mounting holes in the
other end of the Cross Brace and Seat Center Bracket and install
a Washer and Flanged Nut. Again, leave the hardware finger
tight.
Holes for
surface mounting
Washer and Bolt
Washer and
Flanged Nut
Washer and Bolt
Washer and
Flanged Nut
Washer and
Flanged Nut
Washer
and
Bolt
Seat Center
Bracket
6. Attach the other Cross Brace to the Seat and other Seat Support
in the same manner. Leave the hardware finger tight.
7. Turn the bench upright. Locate one of the Arm Rests and position
it at one end of the Bench Seat. Line up the holes in the Arm Rest
with the mounting holes in the Bench Seat end. Place a Washer
on a Bolt and insert the Bolt through the Arm Rest and through
the mounting hole in the Bench Seat. Place a Washer and Flanged
Nut on the end of the Bolt and tighten finger tight. Repeat this
process for the other end of the Arm Rest. After both sets of
hardware are installed, Tighten with the Wrench and Ratchet.
Attach the other Arm Rest at the other end of the Bench Seat in
the same manner.
8. Tighten all hardware while checking with a Level.
9. Move the assembled Bench to the desired location.
NOTE: The feet of the Bench include surface mounting holes in
case a permanent installation is desired. Follow installation
instructions provided with the hardware if purchased.
10. Retighten hardware two weeks after initial assembly.
