User instructions
ArcSplitter 2x12
The ArcSplitter 2x2 divides two LED inputs of the ArcPower driver (s) into 2 branches .This unit is de-
signed for interior use and should be connected to the ArcPower (ArcPower/K2) drivers only.
1. Fixture exterior view
- LED input (line A)
5 - Cable tidy socket (line A)
2 - LED input (line B)
6 - Cable tidy socket (line B)
3 - LED outputs -2 (line A)
7 - Link cable (line A)
4 - LED outputs -2 (line B)
8 - Link cable (line B)
2. Installation
1
. Place the ArcSplitter 2x12 on a non-flammable flat surface in any orientation and fixed it with 4 screws. There
are four mounting holes of a diameter of 5 mm in a bottom of the unit housing. It is also possible to install this
unit to the rack after installing two rack holders (enclosed).
2
. Connect both unit inputs (),(2) with LED outputs of the ArcPower driver (s).
3
. Connect the LED modules to the unit´s outputs (3),(4).If you use all outputs in line A or B, connect the
corresponding link cable (7) or (8) to the socket marked "CABLE TIDY".This socket is not wired, it is only a
"holder" for the link cable to prevent it to hang freely fro mthe unit..
The max. load of each LED output depends on the number of used outputs in the corresponding line (A or
B):
Number of used outputs in one line
Max. load per output
36 LEDs
2
8 LEDs
3
2 LEDs
4
9 LEDs
5
7 LEDs
6
6 LEDs
7
5 LEDs
8
4 LEDs
9
4 LEDs
0
3 LEDs
3 LEDs
2
3 LEDs
