6
● Do
not drop or abuse the tool.
● Whenever a tool is not bein
g used, position the Power Switch to the “OFF” position and unplug the power cord.
Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single finger
notion type) select such a bit whose shank is equal to the size shown below.
Insert the power plug into a receptacle and set the changeover switch to “
F
”
position.
Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start the motor
running.
When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.
To reset the tool by releasing the lever to the original position or releasing the bit From the screw head.
To return the screw, set the changeover switch to “
R
” position.
Hi/Lo Switch
When the TR0206 Series rotating speed needs to be changed, set up the switch to Hi for the fastest rotation, and set
up the switch to Lo for slowest rotation. It's possible that the uncompleted shut-off occurs when the switch is setup to Lo and the
presetting torque is more than 50% of torque range. Please refer to the following table.
Lo Switch
MY9-
0206L
MY9-
0309L
MY9-
0612L
MY9-
0206LF
MY9-
0206P
MY9-
0309P
MY9-
0612P
MY9-
0206PF
OK
3( N.m )↓
4.5( N.m )↓
6( N.m )↓
3( N.m )↓
3( N.m )↓
4.5( N.m )↓
6( N.m )↓
3(
N.m )↓
NG
3( N.m )↑
4.5( N.m )↑
6( N.m )↑
3( N.m )↑
3( N.m )↑
4.5( N.m )↑
6( N.m )↑
3(
N.m )↑
Description of Operation
CAUTION
