Before first use
Before first use, it is recommended to operate the kettle for
2 or 3 times following the instructions below, this will
remove any dust or residues remaining from the
manufacturing process.
·
Remove kettle from the power base before filling.
·
To fill the kettle, open the top lid by pulling on the lid
handle, then fill the kettle with cold water (note: the water
level must be between the minimum mark, 0.5L and
maximum mark,
1.7L). Close the lid by pushing it down
until it clicks into place.
·
Connect the power supply cord plug into a mains power
outlet socket. Press down on the ON/OFF switch, and the
power indicator will light up.
·
When the water has boiled, the kettle will automatically
switch itself OFF. You can stop the boiling process at any
time by lifting the ON/OFF switch. The power indicator light
will go out.
Cleaning
·
First read the instructions in the section titled
“IMPO RTANT INSTRUCTIONS”.
·
Always disconnect the kettle from the mains power outlet
socket before cleaning.
·
Before cleaning make sure the kettle is cool to touch.
·
Empty the kettle. Clean the exterior surface of the kettle
with a clean, damp cloth to preserve its original polished
finish. Dry and polish with a soft cloth.
·
Do not use abrasive cleansers or scouring agents/pads
of any kind inside or on the exterior of the kettle.
·
Open the lid, lift out the filter, rinse the filter under warm
water and brush off any impurities.
·
Refit the filter and lid in reverse order.
·
Only use a dry cloth to wipe the base of the kettle.
·
Avoid wetting the electrical parts.
·
Do not immerse the kettle or power base in water or other
liquid, and make sure the electrical parts are kept dry.
