anko WK8321, Manual

Page: 5 / 8

· Please read these instructions carefully before using the
jug kettle for the first time.
· Before you connect the kettle to the mains supply, make
sure that the voltage indicated on the rating plate, located
on the bottom of the jug kettle matches the mains voltage
in your home. If it does not, contact your dealer and do not
use the kettle.
· The kettle will switch off automatically when the water
has boiled. You may switch the kettle off before the boiling
process is complete by using the Switch-Button.
· After the kettle has switched off automatically (or has
been switched of manually) it may need time to cool
down. After 15-20secs, the kettle can be switched on
again.
· If the kettle ever boils dry, allow 15 minutes to cool
before refilling with cold water. The safety cutout will
automatically reset during this time.
· Place the kettle on a stable flat surface.
· Ensure that the kettle is switched off before removing it
from its stand.
· Never immerse the kettle or cord in water or any other
liquid. Do not allow liquid to penetrate the electrical parts
of this kettle.
· Prevent children from pulling on the mains cord or
knocking the kettle over.
· Ensure that the mains lead does not overhang the work-
top surface.
· Before cleaning the kettle disconnect from the power
supply and wait until it is cooled down.
· Only use the cord supplied with this kettle. If a replace-
ment is required, only approved components may be
used.
·The outside surface of the kettle may get hot during use,
please take care when using the kettle.
· Never fill in water more than the maximum acceptable
water level.
· If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified per-
sons in order to avoid a hazard.
· This appliance is not intended for use by young children
or infirm persons unless they have been adequately
supervised by a responsible person to ensure that they
can use the appliance safely.
· Young children should be supervised to ensure that they
don’t play with the appliance.
· if the kettle is overfilled, boiling water may be ejected.
· The kettle is only to be used with the stand provided.
-Position the lid so that steam is directed away from the
handle.
-Do not remove the lid while the water is boiling.
This appliance is intended to be used in household and
similar applications as:
- staff kitchen areas in shops, offices and other working
environments
- farm houses
- by clients in hotels, motels and other residential type
environments
- bed and breakfast type environments
CAUTION: Do not operate the kettle on an inclined plane. Do
not operate the kettle unless the element is fully immersed. Do
not move when the kettle is switched on.
CAUTION: To prevent damage to the appliance do not use alkaline
cleaning agents when cleaning, use a soft cloth and a mild deter-
gent.
Before first use
Before first use, it is recommended to operate the kettle for 2 or 3
times following the instructions above, this will remove any dust or
residues remaining from the manufacturing process.
· Take up the jug kettle from the base before filling.
· To fill the jug kettle, open the cover by pulling the lid inwards, then
fill to the desired level (min 0.5L-Max.1.7L), close the lid by pressing
it down until it clicks into place.
· Plug the power supply cord into the main, press the Switch-Button
upwards, the power indicator lights up.
· When the water has boiled the kettle will automatically switch itself
off, you can stop the boiling process at any time by lifting the
Switch-Button. The power indicator will go out.
Note:
Do not open the lid when steam is coming out of the spout.
Kettle is only to be used with the stand provided.
Cleaning
· First read the instructions in the section titled “Importance”.
· Avoid using abrasive cleaning agents.
· Empty the kettle and allow to cool, open the lid lift out the filter,
rinse the filter under warm water and brush off any impurities.
· Refitting is the reverse of removal.
Descaling
· Half fill the kettle with tap water and add the juice of 1 lemon to the
water.
· Boil this mixture and allow it to stand for 15 minutes. Re-boil the
mixture and allow it to stand a further 15 minutes. Re-boil this mix-
ture a third time then rinse the kettle well.
Storge
Disconnect the kettle from mains power outlet and make sure no
any water inside of the kettle body. Store the kettle in a cool dry
place along with the user manual for future reference.
4