5
FROTHING MILK
1.
Connect the power cord plug to a suitable power outlet.
2.
Open the lid and attach the frothing whisk onto the rotating shaft.
3.
Fill in cold storage milk (5°C - 10°C). The milk level must be between the marks “MAX
” and
“MIN”.
4.
Put the lid on firmly by pushing it down gently.
5.
Place the milk frother on the power base.
6.
If you want to have a hot milk froth, please press the ON/OFF button 1 time and the button will
flash in a RED colour. The product will shut off automatically after around 2 minutes when the
temperature of the milk reaches approx. 65°C.
If you want to have a cold milk froth, please press the ON/OFF button 3 times and the button will flash
in a BLUE colour. The product will shut off automatically after around 2 minutes.
7.
Remove the milk frother from the power base and open the lid.
8.
Then pour the milk from the milk frother.
Note:
If you want to prepare more milk froth, let the milk frother cool down for a few minutes before further
use. As long as the milk frother is hot, the thermostat prevents it from being used again. You can rinse
the inside of the milk frother with cold water to accelerate the cooling process.
HEATING MILK
1. Connect the power plug to a suitable power outlet.
2. Open the lid and attach the heating whisk onto the rotating shaft.
3.
Fill in cold storage milk (5°C - 10°C). The milk level must be between the marks “MAX” and
“MIN”.
4.
Put the lid on firmly by pushing it down gently.
5.
Place the milk frother on the base.
6.
Press the ON/OFF button 2 times and the button will light up in RED. The product will shut off
automatically after around 3minute 20 seconds, when the temperature of milk reaches approx. 65°C.
7. Remove the milk frother from the base and open the lid.
8. Then pour the milk from the milk frother.
DRY PROTECTION
1.
If there isn’t sufficient milk in the milk frother, it will shut OFF automatically. Nevertheless, always
ensure that there is enough milk in the product, as switching the device OFF automatically can shorten
its life span.
2.
Allow the product to cool down before filling it again.
