anko KJ300GR-G1E, User Manual

Page: 12 / 16

12

Pull out the filters one by one with the fabric belt attached.

Run a vacuum cleaner with brush attachment on low power
setting along the Pre-filter, carbon filter or HEPA filter to pick up
the dust and various particles.

Re-attach filters and the air inlet grille.

When placing the filters back into the air purifier, ensure that the
fabric belts are facing outwards and the filters are facing towards
the air inlet.

Checked the air inlet grille had hooked on main unit and bottom
interlocks fitted properly, or the unit will not turn on.
IMPORTANT! When placing the filters back into the air purifier,
ensure the air inlet grille had locked into place or the unit will
not turn on.
Note: It is recommended that the filters are cleaned every 100-
500 hours of operation, depending on the air quality in the room
and surroundings.
REPLACING FILTER
When the lifespan of the Pre-filter/ Activated carbon filter/ HEPA
filter reach its end, discard the old filter and replace with a new one.
The lifespan and duration of the filter depends on the air quality in
the surrounding environment. The higher level of pollutants, the
shorter the filter lifespan. It is advisable to change the filter at 8-12
months or when filter changing indicator light turns ON.
How to replace filter

Turn off and unplug the unit.

Release the air inlet grille, refer steps show in “Cleaning Pre-
filter, Activated carbon filter and HEPA filter”.

Pull out the filters one by one with the fabric belt attached.
 Install a new filter in position, make sure
back cover had
locked into place.