PAGE 12
Switching on/off (fig. 5)
•
Ensure the switch is in the off position before inserting the battery pack into
the drill.
•
Start the tool by squeezing the trigger switch.
•
For clockwise rotation, hold the drill, pointing it away from you and push the
rotation lever from right to left.
•
For anti-clockwise rotation, hold the drill, pointing it away from you and push
the rotation lever from left to right.
•
When the drill is not in use, the rotation lever should be in the neutral
position (centre), to avoid accidental starting.
Caution:
•
Do not change the direction of the chuck rotation while the tool is in use.
Release pressure from the on/off switch and allow the chuck to come to a
complete stop before changing the chuck’s rotational direction.
•
Do not use tape or any other material to keep the trigger switch pressed
down either permanently or temporarily. This could result in overheating,
damaging the tool, or personal injury,
Starting the drill
•
Ensure that the
drill/screwdriver bit has been installed correctly.
•
Choose the appropriate bit for the application required.
•
The drill/screwdriver bit must be placed firmly on the work piece before the
drill is switched on otherwise damage to the work piece and/or
drill/screwdriver bit may result.
•
Always check the direction of the drill rotation before use.
Drilling wood (fig. 6)
•
For drilling into wood, do not use the torque control.
Select the regular drillin
g
position (See Fig.6).
•
When drilling timber, use a woodworking bit.
•
When drilling into soft wood the drill should be operated at its maximum
speed.
•
When drilling into hard wood the drill should be operated at low speed.
•
Always drill in forward rotation.
6
.
g
i
F
5
.
g
i
F
