IMPORTANT SAFETY FEATURES
1. Your heater is equipped with an Overheat Protection System. When the threshold
temperature has been reached, your heater will turn off automatically.
To reset your heater when the Overheat Protection System has been activated, perform
the following steps:
•
Turn the 'Adjustable thermostat & Power OFF Switch' to the off position '0'.
•
Disconnect the power cord from the mains electrical power outlet.
•
Ensure that both the intake and the exhaust vents are clear of obstructions.
•
Allow your heater to cool down for approximately 25 minutes.
•
Plug your heater back into mains power and turn the power switch to ON, the
heater will resume normal operation.
2.
This heater is equipped with a tip-over switch inside the heater. If the heater is knocked
over, the power to the heater will shut off automatically.
CLEANING AND MAINTENANCE
Before cleaning
-When not in use or before cleaning, always disconnect the appliance from the main
power supply.
Cleaning
-Cleaning should only be done when the unit is completely cooled. Do not immerse
the whole unit in water or other liquid. Do not use harsh solvents on this unit.
-
Wipe the exterior of the appliance with a damp cloth. Dry the unit completely with
a dry towel
Damage check
‐Always check that the appliance
is not damaged, is in good working order and that
all parts are secure. Check the power supply cord and plug regularly for cuts or
damage. For safety purposes, DO NOT use the heater if damage is found.
Store in a safe place
-When not in use, store your appliance and instruction manual in a safe and dry
place.
NOTE: Always clean and store away your appliance with this instruction manual when not
use.
IMPORTANT! This heater is equipped with an air filter net located behind
the air-inlet grille. It requires regular cleaning to ensure trouble free
operation.
Cleaning the filter:
1.
Gently pat the filter or use the
vacuum cleaner to clean the
filter. If necessary, use a soft
brush to clean the filter.
Note:
Do not wash the filter with water
or use harsh solvents.
2.
After cleaning, assemble the filter
back on to the heater.
TECHNICAL DATA
Voltage: 220-240V
~
50Hz
Power: 2000W
Press-down
here to unlock
and remove
the air inlet
grille.
Gently
remove
the filter
for
cleaning.
