The digital screen operation:
1. Connect the appliance to a safety socket, and switch on the POWER SWITCH on the side
panel. After a beep sound, the heater enters into standby mode and the screen shows the
approx. ambient temperature in the room.
2. Power setting:
2.1 Press the ON/OFF button
, the heater goes into "Auto Mode" for heating and icon
lights on.
Note:
Under "Auto Mode", the default setting temperature is 25°C, the heater will start
heating or stop automatically. You cannot set your desired temperature.
2.2. Press the Fan button
and set the temperature higher than the ambient temperature.
The heater will work at high heat output (2000W) mode and the Fan system activates. Both
icons
&
light on.
2.3 The button
is a multi-function switch. Press the button
in turns, the heater can
obtain the following functions.
- Low Heat Output (1000W)
- High Heat Output (2000W)
- Auto Mode
- Frost Protection Mode
Note:
Under "Low Heat Output (1000W) Mode" or "High Heat Output (2000W) Mode", the
Fan system can be activated through pressing the Fan button
again.
Note:
Under "Frost Protection mode'', the default setting temperature is 7°C and when the
room temperature is lower than 7
o
C, the heater will start heating.
3. Temperature setting:
The ambient temperature is displayed every time the appliance starts up.
The temperature can be set when the appliance is operating. The temperature regulation
range is 5
o
C - 45
o
C.
- Press the button
or
to set the temperature. The temperature will increase or
decrease by 1
o
C after each press. The setting will be memorized and confirmed after 3
seconds.
- When the ambient temperature is higher than the preset temperature, the heater will
stop heating.
- When the ambient temperature is lower than the preset temperature, the heater will
start heating automatically.
IMPORTANT! After setting, the shown temperature on the display screen is the ambient
temperature. The heater will start to function only when the set temperature is higher
than the ambient temperature.
