DIGITAL SCREEN AND REMOTE CONTROL OPERATION
THIS APPLIANCE MUST BE EARTHED.
•
Ensure the ON/OFF control switch is in the OFF (position
‘0”) position
before
connecting to mains power.
•
Make sure the appliance, including the plug and cord, is not damaged.
•
Insert power plug into a wall socket with correct power output, 230-240V 50Hz.
The buttons of digital screen located on the product correspond to the remote control
functions.
The digital screen operation:
1. Connect the appliance to a safety socket, and switch on the POWER SWITCH on the side
panel. After a beep sound, the heater enters into standby mode and
icon is shown on
the screen. Press
button to turn on the heater, and the screen shows the approx.
ambient temperature in the room.
2. Power setting:
Press the power button
to regulate low temperature power
or medium temperature
power
or high temperature power
.
3. Temperature setting:
The ambient temperature is displayed every time the appliance is started up.
The default setting of temperature is 25
℃
.
The temperature can be set when the appliance is operating. The temperature regulation
range is 5
o
C - 50
o
C.
- Press the button
or
to set the temperature. The icon
will flash, and the
temperature will increase or decrease by 1
o
C after each press. The setting will be memorized
and confirmed after 3 seconds.
- When the ambient temperature is higher than the preset temperature, the heater will
stop heating.
- When the ambient temperature is lower than the preset temperature, the heater will
start heating automatically.
IMPORTANT! After setting, the shown temperature on the display screen is the ambient
temperature. The heater will start to function only when the set temperature is higher
than the ambient temperature.
4. Timer setting:
A. Under ON mode, press
button to enter into 24 hours TURN OFF timer setting. The icon
will flash, and press buttons "
" "
" to select the desired range between 1 to 24
hours. The timer will increase or decrease by 1 hour after each press. In the timer setting,
the timer symbol will light on and show on the display. The setting will be memorized and
confirmed after 3 seconds.
For example, under ON mode, if you set the timer to 1 hour, the heater will switch OFF
automatically after 1 hour.
B. Under standby mode, press
button to enter into 24 hours TURN ON timer setting, the
icon
will flash, and press buttons "
" "
" to select the desired range between 1 to 24
