N e m o F S R 1
1 3
The scanner firmware is updated and the scanner is restarted. Check from the scanner
information that the IP address has changed. Now you can close the HyperTerminal.
Connecting a GPS Antenna to Nemo FSR1
For optimum performance of the FSR1, it is strongly recommended to connect the GPS antenna
to the scanner. The scanner takes advantage of GPS for timing information which improves the
performance of the signal processing algorithms.
Also note for CDMA/EVDO the scanner must have GPS coverage. If CDMA/EVDO in-building
testing is to be conducted, the scanner should operate at least 30 minutes in GPS coverage
before the antenna is disconnected and then every hour or two of walk testing have an
additional 20 minutes in GPS coverage.
The following GPS antenna is delivered with the Nemo FSR1:
•
Mighty Mouse III
•
28dB gain low noise amplifier
•
Maximum of 6mA current consumption (all voltages)
•
2.5V to 5.5V DC
•
Connector: SMA male
Connect the GPS antenna cable to the GPS connector in the scanner front panel.
Summary of Contents for NEMO FSR1
Page 1: ...Version 6 20 SCANNER GUIDE...
