9
0 - Front cap
1 - Front protective glass
2 - Front element
4 - Front brand ring
5 - Engraved focus ring
Swappable feet
◄►
meter
(see more in section 7)
Available in option
6 - Focus gear ring
7 - Lens support
8 - LEMO connector
9 - Focus ring screws (x3)
10 - Middle brand ring
3 - Front cover
12 - Connector for metadata
16 - Engraved zoom gear ring
18 - Zoom & iris index ring
15
– engraved iris gear ring
17 - Deco red ring
14 - PL mount
11 - Rear cap
13 - Rear Filter Sub assembly
For a standard installation on camera please proceed as below:
-
Remove the rear cap (11) and make
sure the rear filter (13) is clean. If not, please refer to maintenance (section 7)
- Make sure the Optimo Ultra Compact PL mount (14) and camera mount are perfectly clean
- Mount the Optimo Ultra Compact on the camera mount with electronic pins (12) in the correct orientation. Lock the camera
mount
- Remove the front cap (0)
and make
sure the front element (2) is clean. If not, please refer to maintenance (section 7)
- While using motors, to prevent damaging the lens mechanisms make sure the motors are calibrated properly before operating
them
3 - General view and installation
