WARNING: IMPORTANT SAFETY INFORMATION:
Inspect before use for any damage to the unit or power cord. Any damage or
missing parts should be reported immediately and before attempting use. Units
with ANY damage to the power cord should not be used. Contact us for
replacement.
Failure to follow these instructions and warnings may lead to product damage or
personal injury of which
Angelo Décor International Inc.
will not be held
responsible or liable.
1. NEVER leave children unsupervised or out of sight around ANY pond
environment.
2. Always unplug power from lights, pumps or other electrical devices BEFORE
putting hands in water, or if service and maintenance is performed.
3. Always use properly grounded (GFCI) electrical equipment and a drip loop on any
power cords to prevent water from travelling along the cord.
4. Keep the power cord away from high temperatures.
5. Do not exceed the voltage as indicated on the transformer.
6. Do not submerse the transformer in water.
7. Allow light to cool before handling or disassembling.
8. Always use a cloth when handling the lens or bulb. Oil from your skin can
damage the halogen bulb.
9. Do not use near flammable liquids.
10. Do not use in temperatures below 3
0
Celsius as freezing damage may occur.
TIPS BEFORE INSTALLATION
Ensure the lens is clean, free from
debris, and forms a tight seal around
the rubber base of the unit.
Assess the angle and placement you
will require before placing unit in water feature.
Choose an area for your transformer that will protect it from heat sources, excess
water, dirt and debris.
Use landscape materials such as stones to hide excess cord, taking care not to
puncture or damage the cord in any way.
INSTRUCTIONS FOR USE
1. Install cord in water feature on a surface with unobstructed access to the area you
wish to illuminate, keeping plug socket end out of water.
2. Attach the light cord plug socket firmly
to the transformer.
3. Screw the socket cap nut on hand tight.
4. Plug transformer into a GFCI outlet, KEEPING IT OUT OF THE WATER.
REPLACING THE 10 WATT HALOGEN BULB
DISCONNECT UNIT FROM POWER SUPPLY BEFORE HANDLING
Allow unit to cool before attempting to change the bulb. Please use a cloth when handling
the bulb as oils from your skin can damage the bulb.
1. Carefully remove the glasslens by gently
turning and pulling the lens.
2. Gently unplug the bulb from the housing
socket.
3. Replace the bulb.
4. Reassemble the unit, ensure the lens is
clean and forms a tight seal.
