TROUBLESHOOTING
TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 15 hours before their first use.
• To maintain maximum battery life it is recommended that you fully discharge
your batteries periodically. Battery performance can be diminished by leaving
the batteries constantly charging. If your Parent Unit is not in use, please turn it
OFF
.
• Inadequate battery power can impair the performance of your monitor. If you are not
happy with the performance of your Parent Unit/Monitor please replace the
rechargeable batteries (3 or 6 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months
FALSE ALARMS
• Verify the connection between the Sensor Pad and the Nursery Unit.
Unplug and reconnect the cord.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 13” x 13” (33 x 33 cm) and 1/4’’ (6 mm) thick.
• Make sure the Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to
Step 5.1
.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is
ON
.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the crib.
• Turn
OFF
crib mobile, fans, loud music or anything else that may cause vibration.
• You may need to decrease the sensitivity, refer to
Step 5.1
.
NO SOUND IS BEING TRANSMITTED
• Ensure that both units are switched
ON
.
• Check that the sound has not been turned down on the Parent Unit. Increase the
volume level on the Parent Unit, refer to
Step 5.3
.
• If there is no power to any unit check/replace the batteries, recharge the Parent Unit and
check the AC Adaptors are working. Change electrical outlets if required.
• Bring the Parent Unit and the Nursery Unit closer together.
POWER INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check/replace batteries or recharge the Parent Unit.
• Check connections or change to another electrical outlet.
• Ensure both units are on the same channel, either A, B or C.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby’s reach.
• Replace the batteries or recharge the Parent Unit.
18
01mf8_Manuel_NA_AC605_12003.indd 18
2015-03-27 11:42 AM
