OSD MENU
.In normal working mode, press the menu button on the IR remote,
to enter the OSD menu ; press the menu button again to exit and
save modified parameters;
. Use the navigate button to
select the main menu. As above
picture, once been selected, the
main menu will change to grey
color background, and the right
side will show all parameters
under this sub menu :;
menu, press the up/down
navigate button to select the sub
menu, use left/right navigate
button to set the parameter;
last level menu, select the “return”
and then press the left or right
navigate button to get back to
previous menu;
the menu.;
6.OSD Menu Layout:
SYSTEM
LANGUAGE
PROTOCOL
ADDRESS
BAUD RATE
ENGLISH/CHINESE
VISCA,PELCO-P, PELCO-D
VISCA:1~7 ;PELCO-P/D:0~255
2400,4800,9600,115200 optional
DHCP ON/OFF
Defaulted: VISCA
Defaulted: 1
Defaulted:
9600
EXPOSURE
SHUTTER
GAIN
BRIGHT
Defaulted:1/100
Defaulted:0
Back to the main menu
FLICK
B
ON/OFF
GAMMA
0~4
RETURN
Defaulted:AUTO
Defaulted:
11
Defaulted:50Hz
Defaulted: OFF
Defaulted:0
WB MODE
AUTO/MANUAL/INDOOR/OUTDOOR
/ SODIUM LAMP/KEY CONTROL
/AUTO TRACKNG
B-GAIN
Red gain level: 0~255, only valid
under manual white
balance mode
Defaulted:
52
R-GAIN
Blue gain level:0~255 , only valid
under manual white
balance mode
Defaulted:
58
DEFOG
Set the image permeability, should not
be too large, otherwise it will affect
the gray level of the picture
Defaulted:
0
Back to the main menu
RETURN
IMAGE
Defaulted:AUTO
IP address Default:192.168.001.188
MASK
Subnet mask Default:255.255.255.000
GW
Gateway Default:192.168.001.001
RETURN
Back to the main menu
Defaulted:
OFF