Anga AQ-7103VSW, Operating Manual

Page: 10 / 13

using alarm notification and alarm recording.
Add sensor
(this function needs device support)
：
it’s available to add ordinary sensor (door
magnetic, PIR), remoter, special sensor (smoke detector, special gas detector).
Adding methods :click”+” in add sensor interface confirm trigger sensor add successfully.
Using case: switch on “receive alarm prompt” in alarm settings after add sensor successfully. And
at the same time deploying alarm should be done. Once door magnetic is triggered after
deploying alarm successfully, device will send alarm notifications to phone APP.
Firmware update
：
update & optimize device firmware.
Change to standalone mode
(this function needs device support) it applies to the users
without using router. You can get through via AP hot WiFi under this mode.
Users without router can access through device s hot WiFi, details are as follows:
Let device back to the initialized status connect device ’s hot WiFi: GW-AP-XXX back to APP
interface of “configuring camera” and click “skip, shift to AP mode” confirm find the device