For more information on our products, please visit us on our website, www.andymark.com.
Step 5: Build the
interior
box
by using 28” long pipes
as the lengths (4) and 11.75”
long pipes (8) as the vertical
pieces, as shown in Pic 2.
Use GA-2 joints on the top
corners and GA-3 joints
near the bottom, but leave
off the G-2 piece on the
outside of each of the GA-3
joints.
Step 6: Marry the
interior box
to the
floor and handle
, by gently
snapping the outsides of the GA-3 joints on the
interior
box
over the 2.375” pipes of the
floor and handle
. See Pics 3, 4, and 5 for assistance.
Step 7: Install GA-1 joints at the
interior box
leg bottoms, connecting to the 21.75” length of the
floor and handle
.
Step 8: Install the 28” length between the two
GA-3 joints of the
interior box
as shown in
Pic 6. Then, fasten in the G-2 Inner Elbow
piece to hold these pipes in place.
Pic 3
GA-2
Pic 5
Pic 4
Pic 6
11.75”
28”
GA-3
Notice the G-2
piece is not here.
Set one end
into position
Pic shows other end,
before snapping into
position
GA-1
Position of this joint
may need adjustment
G-2
28”
Pic 2
