If disconnecting and reconnecting the refrigerant lines, cover the
ends of the couplings with a plastic bag to avoid getting any
contamination / grit in the couplings.
Never operate the unit in very hot or cold conditions – it works
properly at temperatures between 16 and 30oC
Always allow the unit to stand/settle for 5 minutes before switching
on when either setting or restarting
Position the mobile air conditioner in a flat location where the air
outlets cannot be covered up. Place the unit no less than 20cm away
from a wall or other obstacles
Connect to suitable 230 volt electrical supply. If using extension
cables, make sure they are of the correct cable size and always un-
coil fully from the cable drum.
Fig 2
1.
Power On/off Button
2.
Mode Button (fan speed mode)
3.
LED Auto fan speed
4.
LED Hi fan speed
5.
LED Med fan speed
6.
LED Lo fan speed
7.
LED Dehumidifying mode
8.
LED Fan only mode
9.
LED Compressor running mode
10.
Temperature setting buttons
11.
Display shows the nominal set temperature or the residual
time of a programed time
12.
On / Off timer. The timer function can be used to switch
the unit
On or Off automatically at hourly intervals.
13.
LED timing On / Off
14.
Auto swing button
15.
LED manual water drain required
16.
Infrared receiver. Receives signals from the remote control
1.
Power On / Off
2.
Mode selection button
3.
Temperature set buttons
4.
Louver swing button
5.
Timer set
6.
Fan only button
Controls
Remote Control
3
2
1
4
5
6
